Pass / Fail Lixer A (PF 102-A-ISO) +/-.002″ Lasered Calibration Lines Independent ISO Certification

The Pass/Fail Lixer has a pair lines that are lasered for each push measurement and for each pull measurement, that are +/- 1/32″ from center or +/- .50mm from center. This permits easy identification of standard or metric tape measures that are within this range (approximately +/- 1/32″ or +/- .50mm).

The laser lines can be aligned with the 1/32″ marks on most [standard] tape measures and 1/2mm marks on metric steel rulers. This will enhance your ability to verify accuracy by checking two 1/32″ marks +/- at  6″ or +/- .50mm at 100 mm on both the push and pull measurements.

Pass/Fail A- ISO Lixers come with Independent ISO Lab Certification valid for 1 year.

Accuracy +/-.002″.

Initial order comes with padded Shipping / Storage box.  This box should be saved to use when sending the tool(s) back for recertification.