DIGITEN G3/4″ Water Flow Sensor, Hall Effect Sensor, Flow Meter, 1-30L/min, Compatible with Arduino, Raspberry Pi and Reverse Osmosis Filters G3/4″ Flow Sensor

DIGITEN G3/4″ water flow sensor, Hall effect sensor, flow meter, 1-30 l/min, compatible with Arduino, Raspberry Pi and reverse osmosis filters

Technical data: Frequency: F = 5.5 Q (L / Min), Error: ± 2%, Current must not exceed 10 mA, 330 pulses / liter F = Constant Flow Units (L / Min) Time (Seconds) Flow Range: 1– 60 l/min 5V) Operating temperature: ?80?Operating humidity: 35? – 90%RH Allow compression: Water pressure 1.75 MPa under Insulation resistance: >100 M OhmStorage temperature: -25??80?Storage humidity: 25%?95%RH Output waveform: square wave, output pulse signal. Cable length: 15 cm. Package contents: flow meter x 1

Product Features

• Works for Arduino, Raspberry Pi and reverse osmosis filters. Small , waterproof, easy to install, heat resistance, pressure resistance, cold resistance.
• Material: food grade, all materials meet ROHS testing standards, can be used for drinking water.
• Cable length: 15cm. Flow range: 160L/min, Working voltage range: DC 518V, Allow compression: Water pressure 1.75MPa below.
• Hall effect sensor. Connects to G3/4″ BSPT male thread, required for NPT thread sealing tape when used. Output waveform: square wave, output pulse signal.
• Wide application: It is mainly used in water heaters, coffee machines, water purifiers, drinking fountains, beverage machines, campus smart card devices, etc.