FTVOGUE 3.3V PWM Signal to 0-10V Voltage Converter D/A Digital to Analog PLC Conversion Module

FTVOGUE 3.3V PWM Signal to 0-10V Voltage Converter D/A Digital to Analog PLC Conversion Module

Specification: Model: 3.3P-5V Function: Input 0-100% PWM signal with 3.3V level, output 0-10V voltage PWM signal receiving frequency range: 100Hz – 3KHz (1 to 3KHz is recommended) Insert the jump pin at 5V Analog voltage output: The following is the output voltage of 0-10V, to illustrate If there is no input signal after power on, the output is 0V. When first power on, calibration can be performed: input a signal with 50% duty cycle and 3.3V amplitude DIN- and DIN + one. The frequency is 1-3 kHz. Use a multimeter to measure two ports of AO and GND. Adjust the potentiometer on the board so that the multimeter reads 5.40V. This calibrates the corresponding relationship between the pulse signal and this module. The resolution of this module is 0.1V. The output current capability is 10 mA. If the duty cycle percentage is inversely related to voltage, you can check the STEP LOW, ACTIVE check box to set the PWM output pins in the MACH3 software. Supply voltage: 15-30VDC (power supply current requirement: > 100MA), 12V adjustable Output power: about 10MA Mounting method: 4 M3 screw hole Port: 1. DIN +: Positive of PWM signal (If common cathode, connect to PWM signal; if common anode, connect to 3.3V of signal terminal) 2. DIN-: Negative of PWM signal (if common cathode, connect to GND; if common anode, connect to PWM signal) 3. 12-30V: Positive of power supply 4. GND: Power supply ground 5. GND: Power supply ground. It is connected to the ground of the power supply 6. AO: Analog voltage output port (0-10V) Package list: 1 Digital-Analog PLC Module

Product Features

• This module can convert a 0-100% PWM digital signal into an analog signal.
• This module can convert a 0-100% PWM digital signal into an analog signal.
• The digital input signal can be a 0-100% PWM signal with 3.3V level.
• The analog output signal can be a voltage of 0-10V.

< li>Widely used in the signal interface circuit of PLC, single chip or other industrial control boards.