DPA 2006C Compact Twin Diaphragm Omnidirectional Microphone

DPA 2006C Compact Twin Diaphragm Omnidirectional Microphone

Our unique Twin Diaphragm Omni Mic Capsule is at the heart of these amazing microphones. This capsule gives the mic a distinctive, well-balanced sound and bridges the gap between the extreme sound quality of our pencil microphones and our well-known lavalier microphones.

Combine it with the preamp of your choice
As with all of our modular pencil microphones, you can combine the Twin Diaphragm Omni Mic Capsule with any of our preamps.

The MMP-A Mic Preamp is an ultra-transparent, transformerless preamp with active drive for impedance balancing. The MMP-C Compact Mic Preamp is an ultra-compact preamp with active drive for impedance balancing. It has a slightly softer character than the other preamps for our pencil microphones.

Other preamps include the very small form factor types MMP-E Modular Active Cable (XLR output) and MMP-G Modular Active Cable (MicroDot output), allowing for very slim set-ups. The MMP-G even allows you to match a larger microphone directly to a wireless transmitter.

The 2006C Compact Twin Diaphragm Omni Mic offers a subtle character alteration with a bit more “body” to the low end than the 2006A. It is also much easier to position than other omni mics, due to its smaller size.

At any time, and with no tools needed, it is possible to transform the 2006 Twin Diaphragm Omni Mic into a new configuration.

Technical Specifications

Directional pattern
Omnidirectional
Principle of operation
Pressure
Cartridge type
Pre-polarized condenser, Twin Diaphragm Capsule
Frequency response
20 Hz – 20 kHz
Effective frequency range +/-2 dB
50 Hz – 20 kHz with typ. 3 dB soft boost at 14 kHz
Sensitivity, nominal, +/-2 dB at 1 kHz
40 mV/Pa; -28 dB re. 1 V/Pa
Equivalent noise level, A-weighted
Typ. 16 dB(A) re. 20 uPa (max. 18 dB(A))
Equivalent noise level, ITU-R BS.468-4
Typ. 28 dB (max. 30 dB)
Distortion, THD < 1%
127 dB SPL RMS, 130 dB SPL peak
Dynamic range
Typ. 114 dB
Max. SPL, THD 10%
139 dB SPL peak
Rated output impedance
100 OHM
Minimum load impedance
2 k OHM
Cable drive capability
100 m (328 ft)
Output balance principle
Impedance balancing with Active Drive
Common mode rejection ratio (CMRR)
> 50 dB
Power supply (for full performance)
P48 (Phantom Power)
Current consumption
2.8 mA
Connector
XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: – phase
Color
Matte black
Weight
60 g (2.1 oz)
Microphone diameter
19 mm (0.75 in)
Microphone length
58 mm (2.3 in)
Maximum output voltage, RMS
4.5 V
Polarity
+V at pin 2 for positive sound pressure
Temperature range
-40C to 45C (-40F to 113F)
Relative humidity (RH)
Up to 90%
Sensitivity selection tolerance (at 1 kHz)
+/-1.5 dB