Waterdrop Replacement for Aqua-Pure™ DW80/90 Undersink Water Filter

Model Number

WD-DW80/90

Minimum Operating Temperature

0.6°C/33°F

Maximum Operating Temperature

38°C/100°F

DMinimum Working Pressure

172 kPa/25 psi

Maximum Working Pressure

689 kPa/100 psi

The pressure inside may force the connector to expand, making it difficult to install the system. To avoid this, it’s recommended that you push the new filter in with a minimal force, and then turn it clockwise.

Yes. You should replace the undersink filtration system replacement filter cartridge every 6 months. It may be sooner if the water flow is reduced or there is a heavy presence of sediments in water. Leaving filters unchanged for the long term will lead to fatigue and ultimately degrade the filtration performance.

Yes. It is highly recommended to flush the undersink filtration system replacement filter before using it. Water filters are made from advanced coconut carbon blocks, so you may find some carbon particles in the filter. Therefore, you should flush at first to remove these carbon small particles, leaving you with only pure water.

1. Turn the cartridge to the left (counterclockwise) and gently pull it straight down. Discard the detached cartridge. If you have not depressurized the system properly, there may be a discharge of a small amount of water.

2. Align the tabs of the new cartridges and insert the cartridge from the head. Turn the cartridge to the right (clockwise) until you hear a clicking sound. The cartridge is now properly installed.

3. Turn on the water at the saddle valve or water line and check the system for leaks. If there are leaks, check connections or repeat cartridge installation.

4. Flush 5 gallons through the system (it takes approximately 10 minutes). Residual air may cause temporary cloudiness in water. Place protective shroud back on bracket.

Not necessary. The operating temperature of the filter is between 33℉ to 100℉. Any temperature below or above the limit is not recommended.

Waterdrop filter replacement for DW80/90 can last 6 months or 625 gallons of filtered water; whichever comes first will vary based on water condition. It helps to reduce costs because you will cut the consumption of bottled water.

This replacement filter for water filter DW80/90 is highly efficient in reducing chlorine, sand, soil, rust, sediment, and other impurities, serving you top-quality filtered water.

Yes, you should turn off the water source to the filter before replacing the filter cartridge.

The WD-DW80/90 replacement water filter cartridge for water filter DW80/90 set allows for use on both municipal and well water systems.

Conventional under sink filter

The feed water is sourced from the undersink cold water pipe. It passes through a flexible plastic tube and gets to the water filter. After filtration, it is transported from the filter to the dedicated filter faucet through another flexible plastic tube. The user gets the filtered water from this dedicated faucet right on the top of the sink. The filtration process starts when the user opens the tap, hence the system requires constant pressure to send the water from the cold water pipe to the filter and finally out of the faucet.

Simple under sink water filter

The source water leaves the cold water supply to the filter for filtration and finally dispensed through the regular water sink faucet. The hot water does not undergo filtration. The more common version is one without a distinct ledge as the flexible undersink pipes are easier to use. Unlike the hard copper undersink pipes, the flexible pipes facilitate a simple and cost-effective DIY installation.

Most under sink filters can deliver excellent filtration performance because they adopt activated carbon filtration, present as advanced carbon block filters. The Waterdrop replacement filter for water filter DW80/90 is handled by the premium carbon materials sourced from the Sri Lanka coconut shell. This ensures users always enjoy a superior filtration performance.