403 MHz center frequency and 401 to 405 MHz 1 DB passband SAW band pass filter. Low insertion loss. Highly effective SAW bandpass receiver filter

403 MHz center frequency and 401 to 405 MHz 1 DB passband SAW band pass filter. Low insertion loss. High Effective SAW Bandpass Receiver Filter

Specification: Item Type: Bandpass Filter Material: PCB Impedance: 50 Ohm Center Frequency: 403MHz 1dB Passband: 401-405MHz Insertion Loss: Maximum Transmission Power: 100mW (20 dBm) Packing list: 1 x bandpass filter Note: Pay attention to correct operation.

Product Features

• Parameters: The center frequency of the bandpass filter is 403 MHz, the 1 dB passband is 401405 MHz, the impedance is 50 ohms and the maximum transmission power is 100 mW (20 dBm).
• Excellent performance: The inside of the receiver filter is made of an ultra-thin circuit board, features has excellent suppression capability for out-of-band remote signals and the performance is far superior to bare circuit board products.
• Low band insertion attenuation: The band pass filter has low band insertion attenuation and a steep cutoff characteristic.
• Anti-interference housing: The Saw bandpass filter housing is anti-interference and has no out-of-band interference response.
• Application: The receiver bandpass filter is small, sturdy, easy to use and convenient to carry. This filter is intended for 403 MHz receiving devices to optimize their performance, effectively filter out-band signals, reduce noise and increase dynamic range.