Crown PT 1.1 PowerTech One.One Power Amplifier 210W (2001)

CONDITION

SPENCERTIFIED– Fully certified by Spencer

Refurbished and SPENCERTIFIED

Every function has been confirmed 100% working. We have cleaned it inside and out and replaced any worn parts. A recap was performed if necessary. All pots, knobs, connectors and boards have been cleaned with CRC cleaner.

Cosmetic Condition: Good.

Functional Condition: Works Like New.

WHAT’S IN THE BOX?

• Crown PT 1.1 PowerTech One.One Power Amplifier 210W

Other information about the Crown PT 1.1

• Power output: 210W/CH at 8 ohms with 20Hz-20kHz (stereo); 275W/CH at 4ohms with 20Hz-20kHz (stereo); 550W/CH at 8 ohms with 20Hz-20kHz (bridge-mono)
• Frequency Response: ±0.1 dB from 20 Hz to 20 kHz at 1 watt
• Phase Response: ±10 degrees from 10 Hz to
  20 kHz at 1 watt
• Signal-to-Noise: A-weighted, better than 105 dB below full bandwidth power. Better than 100 dB below full bandwidth power from 20 Hz to 20 kHz
• Total Harmonic Distortion (THD): Less than 0.05% at full bandwidth power from 20 Hz to 1 kHz increasing linearly to 0.1% at 20 kHz
• Damping Factor: Greater than 1,000 from 10 Hz to 400 Hz
• Crosstalk: Greater than 75 dB below full bandwidth power from 50 Hz to 2 kHz, rising linearly to greater than 60 dB at 20 kHz
• Load Impedance: Safe with all types of loads. Rated for 4 to 8 ohms in Stereo, 8 to 16 ohms in Bridge-Mono and 2 to 4 ohms in Parallel Mono mode
• Rugged, professional power amplifier built for the road
• Quick-access front panel power switch and level controls protection
• Patented ODEP circuitry and Grounded Bridge design combine to provide performance and reliability that surpass traditional designs
• Easy to read signal presence (SPI) and distortion (IOC ) indicator for each channel
• High damping factor provides superior control over low-frequency drivers for a clean, accurate low end
• Bridge-Mono and Parallel-Mono modes make it easy to optimize the amplifier’s performance for a wide range of loads
• Balanced phone jack inputs in parallel with XLR input connectors
• Complete protection against shorted outputs, mismatched loads, overheating, input/output DC and high-frequency overload; full internal fault protection

DIMENSIONS

• 19″ x 16″ x 3.5″ (Length x Width x Height)
• Weight: 30 lbs

MANUFACTURE DATE and PLACE

• MFD. 2001
• Made in USA